SSW 06 Soft Starter

WEG SSW-06 series soft-starters are micro-processor controlled and designed to start and stop induction motors. Excellent acceleration and deceleration control is achieved with an optimized cost to benefit ratio. Standard Features
  • 220 - 575V, 50/60Hz input power supply (-15/+10%)
  • Built-in run rated (AC1) bypass contactor
  • Duty cycle: 300% full load amps for 30
  • seconds, 10 starts per hour
  • Voltage ramp or current limit start modes
  • Detachable keypad with dual display
  • (LCD and LED) and copy function
  • 90 - 250Vac auxiliary control voltage
  • Single 32 bit RISC processor based control board
  • IP00 protected chassis enclosure
  • Six isolated 24Vdc programmable digital inputs
  • Three programmable relay outputs (2 Amp - 250V)
  • One 0 - 10Vdc programmable analog output
  • One 4 - 20mA programmable analog output
  • Motor PTC thermistor input
  • RS-232 serial interface
  • Adjustable acceleration (1-999 seconds) and deceleration ramps (0 - 299 seconds)
  • Adjustable pedestal voltage (25 - 90% of line voltage)
  • Current limitation from 150-500% torque control
  • Diagnostic features: Motor overload, over current and phase loss, motor immediate over and under current, SCR over temperature and fault, line phase loss and phase sequence, line over and under voltage
  • Display readings: Motor current, voltage, kW and power factor, line voltage and frequency, four last fault trips, run and power-up timers
  • Ambient: 32ºF (0ºC) to 131ºF (55ºC), 3300 ft (1000m) altitude, 90% non-condensing humidity
  • Braking capabilities: Reverse Braking, Optimal Braking, DC Braking
  • ModBUS ( Built-in)
Optional Features
  • RS-485 serial interface
  • Remote keypad cables and mounting frame
  • PC programming software
  • Profibus Expansion Board
  • DeviceNet Expansion Board
  • Ethernet TCP/IP
  • USB Communication Kit